Hey DM,
I'm running master/e5927b5a3
I have areas setup like this:
...
[21] Zer0Net 9
*[22] CommodoreNet 0
[23] NixNet 8
ie: I've defined a group "CommodoreNet", but not yet added any subs to it.
If, after logged in at the main menu (using the default shell), I type /23 to sw
itch to NixNet, I see no change.
If I type /22, the prompt changes to "NIX" (for NixNet). (/21 takes me to Zer0Ne
t as expected).
If I type * to list the subs, I get this:
■ Main ■ 0:01:17 [22] NIX [1] NIX ADMIN: *
Sub-boards of CommodoreNet Posts
And returned to the prompt.
If I type "NG" (to list the new messages in the current group), I get the NixNet
subs:
■ Main ■ 0:00:02 [22] NIX [1] NIX ADMIN: N
New Message Scan
Sub-board: NIX ADMIN, Group: NIX, or All: G
NIX NixNet Administration New: 0 of 0
...
NIX Running a BBS under *nix New: 0 of 0
Message Scan (8 sub-boards) complete.
IE: I think there is an inconsistency here. Either 22 CommodoreNet shouldnt be s
hown and NixNet should be "22", or "/22" should take me and change the prompt to
commodorenet, and "NG" shouldnt return anything (and /23 should take me to NixN
et as I would have expected).
...δεσ∩
---
■ Synchronet ■ AnsiTEX bringing back videotex but with ANSI
|
