I'm trying to get OpenWRT onto my Linksys EA7500. It doesn't recognize the
OpenWRT firmware as a valid image, and apparently you can TFTP the image to
it if you connect a serial cable to the headers on the board.
I bought a USB to serial cable with separate leads, but misread the
instructions. The router has a 3.3v ttl serial and I plugged a 5v serial
lead into it.
I looked around and found a proper TTL cable, and I'm trying with it.
Now, when I try to get any output from the serial port, I get nothing. I may
have fried the serial port (or I'm missing something). It's a shame, but
it's a perfectly usable router with the stock firmware.
One nice thing about certain Linksys routers is that they have dual
firmware. If it fails to boot three times, it'll fall back to the secondary
firmware image. Keep a stock image on one side, OpenWRT on the other and you
can switch back and forth by powering it up and down 3 times before it fully
boots.
... Move towards the unimportant
--- MultiMail/DOS v0.52
■ Synchronet ■ .: realitycheckbbs.org :: scientia potentia est :.
|
